Please be patient while your browser generates a big table “on the fly.”
Note: this is formatted such that the point where you began is considered to
be point “0.” For that point, the only datum you will need to enter is the
width (if measured) at that point. For each subsequent point, you will also
need to enter the width at that point. Additionally, for each subsequent
point, you will need to enter the length (in meters) from the previous point
to that point (so the distance from point 0 to point 1 will be entered for
point 1), the azimuth (in degrees from north) from the previous point to that
point, and the azimuth “backwards” from that point back to the previous
point (so once again, the readings to/from 0 and 1 would be entered under
point 1).